Electric heating elements need to be checked regularly when they are used in daily use

Need to regularly check equipment in daily use, all kinds of electrical equipment check the connection, but also pay attention to the tightness of site and factory inside connection terminal, the insulation performance of the test should always maintain an annual standard; tightness of tube plate and the container when must regularly check equipment, see will there be leakage, see the wiring box there is no Water Leakage or damp conditions, and pay attention to clear signs of corrosion on all equipment.

If the equipment is damaged the case, to stop using the replacement of the equipment immediately, and the use of the equipment if the ambient temperature is too low, we must do a good job of security measures, this can prevent the freezing expansion heating products cause damage to the equipment; first after gas equipment used before, when after the arrival of gas and stable flow rate in order to give electricity equipment.

This is the introduction for liquid heater, in the choice of this equipment, not only to meet their own needs to ensure the quality, but also pay attention to the installation, service and operation method, only pay attention to the content, in order to effectively ensure the use effect, we can not forget the time of equipment maintenance and maintenance it can prolong the service life of the equipment.

When heated to a certain temperature resistance value will be very intelligent stop heating, but heating temperature of components is better than aluminum barrel temperature is much higher, if it continues to heat conduction, will allow the barrel temperature is much higher than the set temperature, the time required for fan cooling, thereby will waste a lot of energy, the electromagnetic heating barrel is due to direct heating, so it can control the temperature accurately, and does not need the temperature cooling barrel, so the energy saving.

Electric heating wire is a conductive heat element. In the process of resistance heating, the voltage level, the quality of fastening, the oxide film between heating elements, and so on, will affect the damage of the resistance heating element. At this time, we need to replace the heating tube and AC contactor regularly. However, the electromagnetic heating system itself is not the temperature, the high frequency line outside the barrel need only after current does not produce high temperature, so it does not need to be changed frequently, and the heating system does not require AC contactor, thus saving the cost of equipment operation.